Norman Audio

Dan D’Agostino Master Power 3+

The Dan D’Agostino Master Power 3+ brings the acclaimed sound of Dan D’Agostino Master Audio Systems amplifiers to home theaters and advanced 2.1-channel stereo systems. Borrowing heavily from the amplification circuits D’Agostino developed for the Momentum amplifiers, the three-channel Master Power 3+ adds flexible crossover, bussing and bridging capabilities that optimize it for any system, from traditional two-channel to the immersive sound of Dolby Atmos and DTS X.

The switchable crossover filters the bass out of any channel to drive satellite speakers—or the mids and treble out of any channel to drive a subwoofer. Of course, any or every channel can run full-range, too. A single audio signal can be routed to one, two or all three channels. Channels 2 and 3 can be bridged to deliver 1,000 watts into 8 ohms. Power can be controlled through a 12-volt trigger input or through RS-232, and the Master Power 3+ is rack-mountable.

Like the Momentum amplifiers, the Master Power 3+ is built by hand in D’Agostino’s Arizona factory, using expensive through-hole construction for the best possible sound quality and reliability.

Specification

FinishBlack
Power300 watts @ 8Ω
600 watts @ 4Ω
1,200 watts @ 2Ω
Bridged Power1,200 watts @ 8Ω
(Channel 2 + 3)
Frequency Response1 Hz to 200 kHz, -1 dB
20Hz to 20 kHz, ±0 dB
Crossover Filters80 Hz, -18 dB/octave
Distortion300 watts @ 8Ω
<0.1% @ 1 kHz
Signal-to-Noise Ratio80 dB, unweighted
Inputs3 balanced XLR
(XLR to RCA adapters supplied)
Input Impedance100 kΩ
Output Impedance0.12Ω
Dimensions11.5 x 19 x 20 in.
Weight128 lbs.

Downloads

Videos